FishGuy

I believe we have resolved this issue. There is a small spring above the second nozzle. That spring had twisted down a few turns through the hole. This reduced the downforce on the second nozzle when it was swapped.

Thanks MariMakes, I checked the cable. It is snug. I plugged and unplugged it in case there was something caught. The capacitive sensor test is giving numbers below 5, so I do not think noise is an issue. I need some prints, so I have resorted to Ultitune to turn off bed leveling. Not ideal, but I need this to work over the weekend. i will try reaching out to customer service. Adam

An addendum to the things we have tried. We backed up to 7.0.3 firmware. The error persists. So it is not firmware related. Also, we have power cycled the machine, including leaving it off overnight.

We upgraded firmware on our S5 about a week ago. Since then we have not been able to autolevel the bed. Here is what we have done. Manual level clean bed swap bed swap filament reset springs to two turns from tight manual level swap printheads - tried three sizes in left and two in right. Both AA and BB in right upgraded firmware again check capacitive sensor for noise (values ranged from 2.2 - 5.2 over 10 readings in three days) change silicone heat shield check sensor wires check plugs to head board We are all out of ideas. There has been a thread asking to check a log file for 'unrealistic difference' but we can't find that in the logs we have dumped. Does anyone have any ideas we have not tried?