Pride comes before a fall, so a fail was inevitable after being so pleased with my semi-vintage microphone housing, so I am looking for a brain, perhaps younger and at least more potent than mine!
I have had problems previously with layer separation, especially at layers where holes/penetrations occur and also problems with the extruder just giving up extruding [80% through the print this time] and just goes through the motions anyway. Both things happened with this print. I posted something previously and tried most of the suggestions, but the problem remains.
Sorry/not sorry about bombarding you with documentation, but hopefully it gives all the info needed. The material is ABS and the printer is in a non-heated enclosure. The settings compare the microphone housing with the failed print – differences in red clouds and anything greyed out by Cura, I have further greyed out – although they may be relevant to my issue.
Any advice would be hugely appreciated…