Hello! I’m a new user of the Ultimaker 2+ Connect, and I’ve noticed that overhangs have been causing a lot of problems. I’ve tried to read about some solutions to overhang issues, such as altering the fan speed, or slowing down the print, on sites like this, but I’m not sure what else to try, or if I’m doing this wrong.
I’m trying to use this as a good test to know if overhangs aren’t warping anymore:
https://www.thingiverse.com/thing:4690959
My result with default temps (210 nozzle, 60 bed), with the filament that comes with the printer out of the box, (I cancelled the print mid-way once I saw the warping), is attached. This is with 25% infill, and .15 resolution. It will produce one good point, and then all the rest warp upwards.
My fan speeds are default, 100%, and I’ve tried print speeds of 60 and 40, with no visible difference. I have the air filter kit, so the printer is fully enclosed. I also attached the benchmark ship to show more obvious overhang problems.
Is there something more I can try? Thank you so much!