Jump to content

Somnium

Member
  • Posts

    9
  • Joined

  • Last visited

Everything posted by Somnium

  1. Hello i printed a Samurai Mask and had some issues and bc I'm still new to the Cr10s pro v2 and the bouden extruder (my other printer is a direct drive) I though some of you could help me with it. so it was not the first print I made with it and the quality of the other prints was way better but I used a other filament for it so this could be one reason. but the silver filament I printed it with is a very good one. I attached the Project files so you guys can see my settings. I changed some settings for this print that could be the cause -retract from 5mm at 50mm/s to 4.5mm at 45 mm/s. -enabled z hop with 0.2 hop 310820690_OniMask.v1.3mf
  2. sorry for not replying I was very busy and on top of that my printer is out of order due to a firmware bug. but I will print a small piece of the arm to see if the issue is still there and will save the project files so you guys can check on it! thank you all for the tips. I hope I can post something soon.
  3. Ah ok then i got something wrong in the previous posts then i will turn it off and see if this was the cause thx 🙏🏼 dont know why its upside down but you can see the issue on the left side at the visor
  4. i have tried a few things that I saw here like -min. wallflow to 30% -outer for inner wall -combing disabled -compensate walloverlape it helped a little bit but its still noticeable i will try now the extra prime amount set to 1,5 mm3 and retract at layer change so Cura will use extra prime time at the start of the layer right?
  5. Hello there unfortunately I have the same problem!! @kulfuerst what did you do to fix it?
  6. also wenn ich eine Achse skaliere und es dann positioniere überträgt er das in die anderen Achsen da diese immer mit Druckbett ausgerichtet sind und nicht am Model selber also sollten die Proportionen des models dann trotzdem richtig sein
  7. cool danke für die schnelle Hilfe
  8. ok weil wenn ich die Achsen einzeln skaliere zb af x=105% y=105% und es dann positioniere sind diese auf einmal 98% und 102%
  9. Hallo zusammen, Mir ist aufgefallen das Cura je nach Positionierung die Skalierung ändert. Ist das normal?! den ich wollte ein Teil eines drucks Probedrucken um zu sehen ob die Größe passt aber um jetzt exakt das gleich zu bekommen müsste ich es ja auch genau gleich platzieren oder?
×
×
  • Create New...