Jump to content

abeaulieu-tri

New member
  • Posts

    1
  • Joined

  • Last visited

Personal Information

  • 3D printer
    Ultimaker 2+ Connect

abeaulieu-tri's Achievements

0

Reputation

  1. I have a S2+ Connect that's about 5 months old and starting yesterday none of my prints will start. The process gets stuck at "Preparing Print" where it's heating the nozzle and the build plate. I have been able to swap materials fine (nozzle heats up normally) and manually move the material with the utility so the nozzle heating appears to be fine when it's not getting ready for an actual print. I have tried PLA and TPU profiles for some variety and tried a profile with 0deg build plate. None of this will allow it to start printing. If I leave the machine to sit at Preparing Print the build plate and nozzle to not heat up at all. This seemed to have started after I upgraded to firmware 1.5 but I have since downgraded to 1.4 and the issue persists even while trying to run a print I've done before.
×
×
  • Create New...