Jump to content

SEBurke0327

Member
 View Profile  See their activity

  • Posts

    3

  • Joined

  • Last visited

Personal Information

  • 3D printer
    Ultimaker S3

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

SEBurke0327's Achievements

0

Reputation

  1. SEBurke0327
    Bummer, that is what I was afraid of. I sincerely appreciate you verifying and your advice! I will contact the reseller. Thank you!
  2. SEBurke0327
    Hello, thank you for the response! I double checked and the NFC cord is in the correct port. I took the NFC spool holder apart to check on the cords and they seem okay? I have attached a picture to make sure that is what it is supposed to look like.
  3. SEBurke0327
    Hello, I just received my Ultimaker S3 and was putting it together to test everything out, and the initial set up all went fine, however I am getting an error that says "NFC Spool Holder Error". I have tried unplugging it, plugging it in, restarting the 3D printer, and adjusting the NFC cord. The printer went through all of the tests with the Tough PLA and PVA just fine. I'm not sure what else to do, any suggestions would be very much appreciated. Thank you!
×
×
  • Create New...