Hello! I am trying to print a disk made of concentric circles, diameter of 30mm, and is a single layer tall, which is 0.1mm in height. When I went to check the preview, the concentric circles were not printing in an inside-out order like they normally would. I used the same profile settings on a disk with a diameter of 40mm and it printed in the order of inside-out with no problem. I attached a picture of the 30mm disk after about half way through its print, and you can see that I am getting gaps in the printing process. Cura does eventually fill these in, but I need the disk to be printed in order from the inside to the outside. I also attached a .ufp file, so hopefully you can see what I am seeing in better detail. I am pretty new to 3D-printing, so I would rather not have the solution to this problem be to directly go into the g-code. Is there any other way to solve this issue?
Forum_Post.ufp
Forum_Post.ufp