BlueK

I'm using Cura 4.9.1 with Creality Ender 3 V2 and had a long print job end prematurely at 13.4mm of 16mm total height. Estimated print time from Cura was 10 Hr 35 min and job ended at 10 hours and 23 min. It is typical that my print jobs on the Ender 3 V2 take a few minutes less than Cura estimate. But I have not had any print jobs end (as if the print job was complete) without the full job being printing. I realize this is an old thread and is addressing problems encountered in much older versions. Curious if anybody else is having such issues in current version and how they solved it.