Jump to content
Ultimaker Community of 3D Printing Experts

TechLab

New member
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Hello everyone, Ive been using S5 for around 1 year, and until recent few weeks it was superb experience. Recently, feeder started to ground the filament similar as explained on the link problem. When that happen on the display appears the message which says that there is not enough material in the feeder and printing process stops. That usually happen 1.5h or 2h after starting the printing process. Nozzle is 0.4 mm diameter, materials I use are PLA or PETG and almost all settings are kept at their default values. Cura slicer is 4.9.1 and S5 firmware is up to the date. Hot and cold
×
×
  • Create New...