UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Moin,
Es funktioniert wieder. Ich sowohl das Update gemacht als auch die Feeder gereinigt.
Was das Problem also genau gelöst hat...keine Ahnung. Danke für die schnelle Hilfe.
Liebe Grüße.
Moin,
Ich drucke derzeit mit einem Ultimaker 3.
Folgendes Problem.
Als Produktmaterial verwende ich im 1. Extruder ein weißes PLA. Als Stützstruktur verwende ich weißes Breakaway-Filament im zweiten Extruder.
Wenn ich das Material im 2. Extruder wechsel kommt nach einer Weile ordnungsgemäß flüssiges Filament aus der Düse.
Während des Drucks jedoch nicht mehr. Reinigung mit Reinigungsfilament habe ich auch schon durch...
Liebe Grüße.
Hey,
i have some problems with my last print. The surface of the inner circle is nearly perfect.
BUT the outer ring and lower surfaces are as bad as you can see in the pictures.
Is there a quick fix by settings possible?
Thanks,
Mike.