Jump to content

theobituary

New member
  • Posts

    2
  • Joined

  • Last visited

Personal Information

  • 3D printer
    Other 3D printer

theobituary's Achievements

0

Reputation

  1. NEVERMIND! lol i found it...somehow "remove all holes" under mesh fix got checked. No clue how i managed that as i am pretty much never in that section of settings
  2. I have modified my printer a good bit and started trying other slicers but i think i may have changed a setting in Cura (4.10.0) and i get material where there should be holes. I have printed this .stl before but recently it broke while printing ABS (got some almost free otherwise i would have used petg) and figured since i have the ABS i will reprint the part in that since its better with heat than PLA and my PLA bowden tube clips did warp from the heat while printing my first parts from ABS. This .stl shows up fine in prepare view but after slicing all the holes are printed solid (except the angled slots on the vertical part) and as far as i know the only thing i changed was the infill percentage. May have checked "compensate wall overlaps" on a prior print but unchecking that and changing the infill back has no effect. Most recent change was a Microswiss all metal hotend and test print in PLA sliced and printed fine..plus that should not cause this anyway. i attached the prep view and preview screen shots..again same exact .stl file i didn't re-download and printed 2 prior sliced in cura (older don't remember version but it was only 6 month ago, this is on a CR6se with tthe original screen bur with a BTT mobo)
×
×
  • Create New...