AniNitro

I've attempted to contact them. I was wondering if it was with the cura code that I was having trouble with.

I Just set up and put together my printer, When I sliced a model in cura with the settings recommended from the xvico3d.com manual. When I hit print. The screen shows 2 arrows in and out.. Then a few seconds later it shows "Heating nozzle temperture" Slecect OK. When I hit okay. THe print screen flashes up and then disappears back to the first screen that shows Printer > Filament Screen with Two areas and an OK button. A few seconds later it shows again "Heating Filiment" Press when ready OK. It says this continually. WHen I hit OK, the print proceeds for 3 seconds then lifts up and the screen appears again to hit OK, ect... It never gets out of this.. Does anyone now what is going on?