Jump to content

hichemhich

Member
  • Posts

    5
  • Joined

  • Last visited

Personal Information

  • 3D printer
    Ultimaker Original (+)

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

hichemhich's Achievements

0

Reputation

  1. Hi everyone ! i just have a question : is it possible to update the firmware with ultimaker controller via SD ? if yes how ?
  2. Hi again i have tried to contact 3DPrint.tn but no answer... do ultimaker still sell "ultimaker pcb 1.5.7 control board" cause i can buy it from france if existed !! if no can i use another control board ? if so which one ? i'm really in the average of losing hope to fix this .. !!!
  3. thank you for responding 🙂 yes i mean the full electroniques are missing i have Ultimaker original with no heated bed what i have mounted now are : 4 stepper motors, 6 endstops,2 cables for lcd, 1 tempeture sensor for the extruder, and 2 fans (one for the extruder and the other for the missing board v1.5.7), and 2 lcd cables here's a picture that could be helpful
  4. Hi everyone i'm totally new to 3d printing i just got my hands on a UMO without a board control (v1.5.7) i have tried finding it for a while but no luck. i searched i lil bit about board control that can replace it so i found most of the ppl use the ramps 1.4 my question is will it work on UMO ? if so does it take the same power supply !? also if anyone have another ideas i'm all ears.
×
×
  • Create New...