Jump to content

Ocariduc

Member
  • Posts

    4
  • Joined

  • Last visited

Personal Information

  • 3D printer
    Other 3D printer

Ocariduc's Achievements

0

Reputation

  1. Possible bugs... I have been using 5.4 for a while, and have not had any problems with the Ender 3 V2 printing PLA. But I have a surprise today: I attempt to print the following frame (3mm wide struts): But I end up having a filled part. I checked the preview after slicing and it does show a filled part ! What could be the problem?
  2. Many thanks ahoeben, you have found the solution. Mold was indeed activated by accident and this option carries over from update to update.
  3. Help with a very strange bug after Cura version 5.1.1: the design is a simple block (block.jpg attached). Slicing with 25% infill in the new 5.3 gives the preview shown in block2.jpg: not the same block at all. The picture at a lower layer (block3.jpg) confirms it is not the right sliced version of the original design. Now, using Cura 5.1.1 (the last version not showing the bug described above), picture block4.jpg shown the right sliced block. Pictures at 2 lower layers (block5 and block6) show how a right sliced design should be. The problem does not replicate on my second PC. What could this be ? Many thanks.
  4. In preview, I only have color change for Line Visualization. I google everywhere but no-one seems to have the problem. I even uninstall, delete manually all configuration and re-install. Anything obvious I overlooked ?
×
×
  • Create New...