Thanks. I can see there is always something to Sacrifice between quality/printing time.
I've been slicing a very complex skull (approx. 100x100x114mm)
- Loads of overhangs
- 1.2mm wall thickness 3 wall lines
- 0% Infill & 0.2mm Layer height
- Speed (40-60mm/s and 30mm/s Top/Bottom) plus 150mm travel speed.
The biggest problem is the time spent building supports even using,Zig Zag build plate only and 12% support density.
But I am afraid If Increase speed It's very likely to brake parts as the nozzle travel between overhangs/bridges or those thin supports.
I tweaked several acceptable options but I don't really want to go lower than 0.2mm quality neither split the 3d model.
I rotated the 3d model in several positions and still with the above speed/Quality It's so frustrating not being able to get a print under 8 hours.
Regards,
Andy