vavaroutsos

I can confirm similar results from cura 4.13.1 to cura 5.1. With cura 5.1 I actually get small holes in areas that are only 1 or 2 walls thick, where as cura 4.13.1 printed fine with the same settings (except some support settings).

Thank you for the very helpful reply. Is there anyplace where subtle changes like this between releases are summarized?

I just upgraded to Cura 5.1 from 4.13.1 and now I'm seeing this problem. The same settings weren't generating this problem with 4.13.1. See layer 132. UM2E PGV19.2_0.4 Generic ABS lw 0.6mm lh 0.2mm if 100% ext1 245.0C bed 105C.3mf

When I connect to an octoprint server with the moonraker connection plugin installed, the monitor tab doesn't work. There is a message that says "In order to monitor you print from Cura, please connect the printer.". There are no errors in the Cura log. If I remove the moonraker plugin, everything works properly. Should these two pulgins work together? Is this a known issue?