bastl

Hello Before retraction it gives extra amount of filament of about 1mm at high speed, and than it retracts my 12mm but of course with no success. Wipe is configured to travel 2mm inside the printing but it does not so i turned it off. Cura-4.11 Ender3-v2 Retraction I want: travel given distance inside printed area(best 1 circle) while retracting given mm filament at given speed, then travel and then shift the filament with given speed over yet printed area back. Retracting more than 5mm gives no better result! I think that this 1mm push causes the bad retraction ? Any hint is welcome... Many thanks in advance !