Hi! I've been 3d printing for about 2 years now and only have used Blender (version 2.91 I believe) and Ultimaker Cura (now version 4.11) for all my prints, but recently when I go to print out a new mold my printer only prints in a zig-zag in the same spot. I let it go for a minute or so but it still was doing the same spot. I've tried a old test gcode I made to level my bed and that works fine. I'm not sure if it is something i have done to my settings, or if this was an update on either program, help would be greatly appreciated!!