Jump to content

techstacy

New member
  • Posts

    1
  • Joined

  • Last visited

Personal Information

  • 3D printer
    Other 3D printer

techstacy's Achievements

0

Reputation

  1. Cura 4.11.0 Printing a 300mmx370mmx3mm grid consisting of hexagons. outer before inner: enabled The issue I'm encountering is during the printing of initial layer instead of printing in one continuous adjacent area ie left to right / top to bottom etc, it's printing 20% on one side.. picking up the print head and moving it across the print surface to print a single hexagon or two.. then moving back to the edge to complete another 30% of the print. Each time is does this there's a chance for error. This seems to change randomly any time I slice the print. Some times it will print mostly adjacent.. other times it's all over the board. Is there a way to configure Cura to lay the print out so it's always printing adjacent to existing material for support?
×
×
  • Create New...