Jump to content

Iceman1768

Member
  • Posts

    4
  • Joined

  • Last visited

Personal Information

  • 3D printer
    Ultimaker S5 Pro Bundle

Iceman1768's Achievements

0

Reputation

  1. Did you see the pictures I sent? We will have revisit all of our saved parts.
  2. It doesn't support at all..the bottom of the part looks terrible. The support barely supports itself.
  3. After Upgrading to Cura 5.1, the support structure seems to have changed. Please see the attached file. It compares 5.0 to 5.1 with the same settings. This part is saved in our Digital Factory and we pull it from to print. Cura 5.1 vs 5.0.zip
  4. IN the pic below the the blue circle points out a bulge. It is not in the model and not in the cura preview. It does it here and on the opposite side. Using Tough Pla and engineering Normal settings. Have played with different speeds and wall thicknesses, but still there. The only way I got rid of it is to lay it on its side.....but still wondering if there is a setting that causes this. Thanks
×
×
  • Create New...