ChrisXross

Thanks for the help. I will check these settings. I did try normal supports and the same thing happened - only one support generated. Strange this is that this morning I revised the print temperature and build plate temperature down by 10C and switched off the fan (it was at 10%) and re sliced, tree supports were then generated for all three holes. I’m using ASA, it’s recommended not to use a fan so supports are required. Will switch back to normal supports.

I am slicing a model that has three structures that need supporting - but Cura is only generating supports for one of the structures. I have tried using support blockers and using per model settings to tell it to create supports but this doesn't produce anything better. have tried Tree and Normal, both produce the same result. Not sure what is going on.

I'm having a lot of issues slicing models using my Mac, sometimes they won't slice at all other times they won't slice in one orientation. I have reported this twice as a bug and sent the log file and the model but not had any feedback - I can slice them using my old windows 10 laptop - but it's a pain to keep porting them across. Is anyone else having similar problems