Hey folks. I've been trying to print some items that end with a few layers of single lines. However, Cura's been doing something weird that I can't understand which is ruining my prints. I've attached a picture of the sliced print. The printhead goes around the layer (starting from the yellow circled start point and going left from this perspective), prints the whole layer flawlessly, and then for some reason hops to the "start point" marked with green and then the one marked with blue. Apparently it does nothing at those points (especially considering they are completed lines), but because of the hops, it leaves a gap at the start of the next layer, and does that layer after layer. So is there any way I could erase those unnecessary start points, or does anyone have any idea how I could make this print come out as it should? I've tried reducing the retraction distance in hopes of fixing it, and I think I maybe could push it even lower, but I'd rather fix the issue itself than go with a workaround that would reduce print quality as a whole.