I have this weird problem. There are some STL files I just can't get to print as the Gcode generated by Cura makes the hotend go at coordinates 250 on Z and 220 on X. Then the bed start moving and the filament is dropped in mid air.
If I stop the print and start another gcode I know works fine. It does exactly the same. I need to remove the memory card and turn of the printer and then restart it before inserting the memory card to be able to print again.
I already have the latest firmware from Creality.
Here are an example of the files I get problems with.
Here is my setup:
Stock Ender 3 V2 except for the bed springs.
Creality firmware 1.0.4
Eryone Red PLA+ 1.75mm filament
CE3_4010_Lightweight_Duct_Standard_Right.gcode 4010_Lightweight_Duct_Standard_Right.stl CHEP4.11_0.20(Good).curaprofile