Jump to content

sifugreg

Member
  • Posts

    2
  • Joined

  • Last visited

Personal Information

  • 3D printer
    Other 3D printer

sifugreg's Achievements

0

Reputation

  1. Just for a point of interest, I purchased some nylon over a year ago but never used it. Still sealed in the factory plastic, with Dessicant, never exposed to atmosphere from the factory. When I finally upgraded my hot end and dug it out for first print, it too, snaps, crackles and pops.
  2. Two parts in this print, all supports are perfect except for these little offset rails (see image). This is the very first design I've imported into Cura. Same design has no issues with supports in my other slicers. Now, my default is to assume I don't know what I'm doing but in my other program, I can add my own supports should I not agree with the software's decisions. I've adjusted the various parameters available in Cura, but nada. Thoughts or Guidance?
×
×
  • Create New...