Jonas_2603

100% in on that request. Would be a setting I would use on probably every print. And since Initial Layer Horizontal Expansion is already a setting it should not be that difficult to implement.

I have tried to slice the following model from thingiverse: https://www.thingiverse.com/thing:4706119. When slicing the model with one of my custom settings, the skirt arround the model started to overlap with the printed parts of the initial layer. I then tried to slice the model with one of the standard Cura profiles which sloved the problem. But i could reproduce the same overlapping by changing the "Hole Horizontal Expansion" from 0mm to 0.25mm and the "Initial Layer Height" to a value between 0.15mm and 0.22mm. Outside of this range the problem didnt occur (while having the worst overlapping at arround 0.19mm like seen in the picture). Any idea on whats causing this problem?