I am a very basic user and I need help. My current set up is a 2017 iMac 27" 5k with Montery OS, Ender 3 pro with Micro-swiss direct drive & hot end.
I had some problems when I installed the direct drive, but got it working with some help from MicroSwiss. Then 2 weeks later and several successful prints, I upgraded to the new Cura 4.12.1 software. When the printer reaches temp and starts moving the head to the starting point the"X" & "Y" axis motor spins for a few seconds after the table is at the end of their travel. Sounds horrible as the drive gear slips past the belt teeth. Also, "Z" starts at about 10mm for the bed and it starts to print hanging in mid air.
HELP!!!!
TIA
Tom,