lvgully

I am attempting to print this flat so it will print...I'm using Cura 4.1.3...see picture. It's the inside of a cell for my son's school project. Thanks.

Hi...BRAND NEW to 3D printing and have a Monoprice MP10. I have been using 4.12.1 on the Creality CR-10 setting since there is none in the software for my printer. It's been working fine but the placement of the print area is always off center. This even though the sliced version shows it center. Anyone offer a Noob advice on why this might be happening. Thanks in advance and lots to learn!