Jump to content

Songaeki

New member
  • Posts

    1
  • Joined

  • Last visited

Personal Information

  • 3D printer
    Other 3D printer

Songaeki's Achievements

0

Reputation

  1. Hi, I am currently using an Ender 3 Max and Ultimaker Cura 4.12.1 to slice a calibration cube linked below: https://www.thingiverse.com/thing:1278865 My problem is the top is not printing. I printed it again and watched the end and it just finishes at a corner of the wall then ends the print. It does not even seem to try to print the top. I am assuming it is some print setting I have setup for my printer in Cura but I am not sure which setting would keep it from printing that last layer. Any Ideas? Lost Newbie.
×
×
  • Create New...