B550 AORUS ELITE V2 mobo , AMD Ryzen 7 5800X, amd rx5700XT . I only mention that because Ive had some issues with kernels and firmware for my mobo on my linux installation. But might not be relevant.
From the searching I did that was also a possible solution i came across. I've tried manually allowing the program through windows firewall since I don't use any other antivirus.Is there any other steps i could do? I do have surfshark VPN but its basically never on?
Yesterday i sliced some stuff and printed; but today it is again just stuck at the infinite loop. log attached again for perhaps some new info.
*Edit, if its firewall issues why doesnt running it as admin solve it?
Thank you for answering, ive been using cura for a long time and really hope to get this issue resolved 😉
cura.log
**EDIT i made a new log after i shut down my (not running) vpn, since I didn't see the same error in the log.
I was trying to reproduce that same line , and i marked where it freezes and where it continued logging after i pressed CANCEL on the program itself. hope this is helpful.cura.log