Jump to content

BobBest

New member
  • Posts

    2
  • Joined

  • Last visited

Personal Information

  • 3D printer
    Other 3D printer

BobBest's Achievements

0

Reputation

  1. Wow, thanks so much I would have never found that. I never paid much attention to the experimental section so I'm amazed that it would be set, maybe it was the default? So originally I had supports on so why do you think that this experimental option would take presidence over supports? Thanks again!!!!
  2. I have been using Cura for over a year and this is the first time I've experienced this type of behavior in the slicer. I could be something I'm doing but it goes away if I print it in a different orientation. I thought it may have something to do with support but it happens even when I turn the support off. The angle starts at layer 119 and adds extra material in the vertical slot. Any Ideas? TWOTSP_Test Piece.3mf TWOTSP_Test Piece.gcode Test Piece.stl
×
×
  • Create New...