Jump to content

nz3dtinker

New member
  • Posts

    1
  • Joined

  • Last visited

Personal Information

  • 3D printer
    Other 3D printer

nz3dtinker's Achievements

0

Reputation

  1. I'm using Cura 4.6.2 at present and wonder if it is possible to modify the infill generation. Some models I make are basically a 1.8mm plate with something on top. Normally Cura generates an infill that is reflective of what ever is on top. Even with 100% infill the infill does look funny: Ideally what I would like to achieve is an infill pattern, that does not take 'note' of what is on top like this (even if I set the infill to something less than 100%!): I know why Cura is doing what it is doing, but in this case, i would like to use a 'modifier' that tells it to not look ahead and simply fill each level on it's own. I have a solution of sorts, but it involves a convoluted process of making two models, slicing them separately and then joining the gcode with the help of a program I wrote. I hope there is a way to eliminate the extra steps?
×
×
  • Create New...