Wobberjockey

I had this problem shortly after loading up 4.13, and now it is affecting ALL versions of Cura. I can't use any of them, no matter how often I do a clean install the issue is this: If i attempt to do any sort of modification of my settings, the program will not launch next load. i never see the UI, just straight to not-responding when loading the build volume. if i attempt to save the profile? not responding. any subsequent program runs? not responding. deleting the Local and roaming Cura folders helps, but again... not responding after the first run. if i take too long to slice the model? not responding. Right click? not responding. at this point i have clean-installed and set up my printer about a dozen times just trying to get a single file to print. it's a race against time before cura tries to save the profile and necessitates a total reset. i tried going back to 4.12.1 after the issue, but the issue is now following me back through versions. I've also tried running as admin, with no success. it is however more stable, and i can slice something... but it pretty quickly falls back into the same loop of not responding. usually after trying to save my settings i've updated the OS, and both SCF /scannow and the DISM repair commands are coming back clean. i've deleted the local and roaming Cura folders I've even gone so far as to delete all the cura instances out of Program files after uninstalling. it is still happening. i am really at my wits end here because i have no idea what the application might be doing that's causing this crash. edit: now it's any menu item. i can't even click 'file'. cura.log stderr.log