Multitube

Hi Geert, Thanks for the reply. Temperature would be my first guess as well, but since we have no problems at all with all other profiles I figured there would be something else going on.

Hi! When printing with Ultimaker PLA on my S5 Pro Bundle and an AA 0.8 print core, the sides of the prints are 'caved in', see attached image. The middle is around 1,5mm under sized, top and bottom are ok. I've used the default Ultimaker profile, with the only difference being the layer height (0,4mm) See attached 3mf and ufp files. I've never really experienced any shrinkage using PLA and the problem doesn't occur when printing with Ultimaker Nylon (which is my go-to material). Any idea's? Thanks! Tim UMS5_X21-0000079-Rev_-.3mf UMS5_X21-0000079-Rev_-.ufp

After finishing a print earlier today, the S5 is offline in Digital Factory. Print over network in Cura is still available and the printer is connected to the network as it always have been. I've restarted the printer, re-initialized DF on the printer and (after a couple of tries) added the printer. It showed up as 'online' for a moment, but when I went to the DF library to start a print, the printer was offline again. It's getting frustrating, I've got prints to make and I've wasted a couple of hours today trying to fix it. I'll start the print from Cura for now, but that's not why we spend big bucks on a complete solution... Now for the kicker: after starting the print from Cura, the printer suddenly goes online in DF.. The S5 is on the latest firmware. Any ideas on how to get it back to work? Thanks!