Hey there. I'm rather new to 3D printing. I was wondering if I could get some help.
I design original files in Blender 2.79b, slice them in Cura 4.3.0, and send them to the printer. ..At least, that is the plan.
What happens is that I put the exported STL into Cura and that's where things go wrong.
Problem 1) The 1cm*1cm*1cm cube gets enlarged to 1,000,000% bigger. So i resize it to approximately what it should be.
Problem 2) The voids inside the project that should be hollow, are completely filled in. (Example of a simple box attached)
Problem 3) I don't know if Cura is a resource hog or what, but every 3 seconds or so, it freezes my cursor in place for one second, then carries on.
I can't find any help online and I thought y'all could help me out here. Ty