bonemaster

The M25 worked, sorta. It pauses and parks where I told it too, however it doesn’t resume. The only way it will start printing is if I click pause print on printer menu and then click resume. Any advice?

Thanks. I use a layer number to pause it. I did upgrade to the silent board recently.

Ender 3. Under the post processing I have it pausing at a certain layer height so I can do a filament change.

Using cura 4.13. Pause at height is not working. Chose the height/ layer number at which to pause; printer doesn’t pause and just continues to print like no code there. Have tried realizing several times, get same results.