johnnieq

GregValiant Your 1st suggestion to try using the "Gcode after pause" box in Pause at Height worked fine. I never had to go any further to try the others. Thanks!

Thanks I'll give this a try tomorrow morning. I'll let you know if it works. 😉

As the title says, I cannot get "Pause at Height" or "Filament Change" to work on my Ender 3 v1. "Filament Change" does nothing for me. :( "Pause at Height" does nothing either, unless I modify the gcode and replace the M0 entries to M25. Then it will stop printing, and move the print head out of the way for only a few seconds. I have no time to change the filament. Is there a setting I am missing? Is there a gcode command that will make it pause a set amount of time? or one that requires an action from me to restart? I haven't been able to find an answer anywhere. My Printer is a Creality Ender 3. I believe it is a version 1. The motherboard says 4.2.2 and the chip is a STM32F103RCT6.