UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Hallo,
ich wollte gerade einen Z-Offset-Test slicen (0.2mm Höhe), doch Cura erkennt nichts, was gedruckt werden könnte, obwohl das Objekt erkannt wird (siehe Foto). Hat jemand eine Ahnung an welcher Einstellung das liegen könnte?
MFG Gnutzie