Was using Cura 5 ok and updated to 5.2. Since then I have noted that my prints have fallen off a cliff! Not sure what settings would cause this issue. I had printed a couple of these boxes ok but this latest one I just hit it and it split in two. I could see the "fault" line in the print and it felt "creaky". A good hit and it split cleanly. Its like it hasn't joined properly at a layer.
Also I have noted that the walls appear to be individual. they are not joined, either by extrusion or by infill. This has happened on quite a few prints. Just seems to print each one (wall) individually and not squeeze enough to force the lines together.
I use a Prusa at home and wouldn't be buying an Ultimaker or using Cura myself. Stuck with it at work 😞 so any ideas would be appreciated.