hhassan

Here are the results. Overall it printed well but there is still some visible distortion/shift on the X Axis. It only seems to impact sharp corners. This does not better than the calibration cube, but I did use the beta version of Cura 5 for this one. Not sure if that helped. Note: This is printed with ABS

Thanks for sharing the file. I'll start the print in the next hour and share the results soon after

Similar problem ☹️

Here is the gcode for the file in question Calibration Cube.gcode

I would like to consider myself not a newbie to 3D printing, but I have come across an issue that I have not managed to resolve. My printer is an Anet A8 custom build with extrusion frame and linear rails. The extruder and housing design is taken from the Voron 2. I am using Klipper as my choice of firmware and have dialled in all the setup parameters, such as extrusion, pid for print head temp, bed screw levelling and mesh bed levelling. I started off printing a calibration cube and the results were disappointing. (please see attached photos) The edges, in particular on one side of the Y axis, seem to be distorted, the opposite side seems fine, apart from the elephant foot at the base. I have ensured there was no play at the print head and all belts were correctly tightened. Can anyone shed some light on this?