Root720

Hello! I use a BLTouch with an Ender 3V2, and I am having issues with getting an automesh to be read. I am able to create the mesh properly, but do not know how to go about applying this mesh to prints. Everything I have seen says to add the code down below to the GCode files, but it does not seem to make any difference as the nozzle height is not moving or adapting across the bed. I know this forum does not apply much to the hardware, but I was hoping there was something I was missing on the software side of things! Any and all help is appreciated!

Okay thankyou so much! Interior didn't matter as much, as I was just using it for the shape! I wasnt sure how to go about repairing or anything like this so this helps a lot!!!

Hello! I am looking to print out the following file laying on its side as a piece to decorate my graduation cap, but whenever I go to print it, it is consistently missing chunks of it. When standing vertical, it misses pieces of the bell, when on its side the entire bell is gone. Is there anything I am missing, any way I can repair the file, anything like that? All help is greatly appreciated! Saxophone Half.stl