In Cura 4, when I printed bowls, cups, vases, etc in spiralize mode, the bottom layers would have circled borders with lines in the middle. This was great and always resulted in a excellent interior bottom surface.
Now in Cura 5, when spiralize is selected, the bottom layers are printed completely in a circular pattern which is not nearly as smooth and results in a blob in the middle.
Is there any way in Cura 5 to force lines for the bottom layers when spiralizing?
I'm using an Anycubic Vyper and i've attached the profile.
Cura 5 PLA spiral .8 width.curaprofile