jamesphendry

Hello Greg Thankyou for your reply and the information. I have tried to install Cura 5.0 but keep getting a error message saying my Video Card Drivers require updating to openGL 2.0 and above. The desktop computer I use is old and probably does require a overall, this is in hand. Again thank you and keep up the good work. I will let you know how I go on. Regards Jim Hendry

I have a Anet A8 printer and this has been working fine with some very good prints. A few weeks ago the prints have been too wide and deep with the height being fine. I printed a 20mm test cube which printed X axis 25mm Y axis 25mm and Z axis 20mm. So I then printed a 10mm test cube this printed X axis 12.5mm Y axis 12.5mm and Z axis 10mm. Any ideas and remedies please but in plain language.