Beretta031

I'll post the final product soon!

YOOOOOOO!!!!!! Thank you so much for your help!!!!

Thank you so much for your help. I will be giving it a whurl tomorrow.

@MariMakes This is work correct? In the sense that where the blocks are placed supports shouldnt be built there correct?

Sorry about that, I am printing on a Ender 3 Pro.

Attached is the stl file. I found the same stl file but with tree support built in. The tree support didnt do too well. Although I guess it could have been a bed leveling issue, but I havent had any issues with any of my other prints and I did recheck the bed all was fine. Muscle_Trophy.stl

I am trying to create custom supports in Cura 5.2.1. As you can see I need supports under the hands. Here is what I have so far. I have support placement Everywhere and then I used support blockers. My question is how to I get supports right under the hands and not from the top of the arm up to the hands covering the trophy handle?

Thank you!

Is there a way to reset the print settings back to the default?