Heya,
Not sure if this is the right place for this or not, but figured it'd be cool to get a little help if possible.
I've got the pause at height command set to a layer of my build using the M0 method, and all that's working fine and dandy. However, I noticed on resume of the pause that my hot end immediately cooled off and the print aborted.
Inspecting the gcode cura generated, I saw that instead of resuming the hot end temp after standby, it decides to drop it to zero.
;added code by post processing
;script: PauseAtHeight.py
;current layer: 12
M83 ; switch to relative E values for any needed retraction
G1 F300 Z4.640000000000001 ; move up a millimeter to get out of the way
G1 F9000 X190 Y190
G1 F300 Z15 ; too close to bed--move to at least 15mm
M104 S205 ; standby temperature
M0 ; Do the actual pause
M109 S0 ; resume temperature
G1 F300 Z3.64
G1 F9000 X117.463 Y113.386
G1 F300 Z3.64 ; move back down to resume height
G1 F1500 ; restore extrusion feedrate
M82 ; switch back to absolute E values
G92 E582.44268
Any idea why this is happening? I've sliced it a few times with a couple of different settings, but it doesn't really make a difference. As soon as I hit resume I have to be real quick about manually adjusting the temperature back.