Plantos

Bob Lid 3hrs.gcode Bob Lid.stl

Hiya..........many thanks. It was my model which I found the 0,2mm different. I have corrected now but another issues arises after I printed the same model but with a different name to mind. Attached are photos shows the lumps. My settings in Cura was see attached snap shots. The thickness of the lid is 2,00mm and the depth of the name is 1,00mm. I did not turn on the fan on my printer machine then, maybe it was the issue with 100% speed and I have reprinted again and there are a small couple of lumps again with speed at 65% and the fan on this time. Oh.........I hate seeing these lumps appearing and what caused the problem. Please advise again and many thanks for your help and input. Take your time.

Many thanks for your reply. Where would I find the 'Z' in Cura settings ? A snapshot please.

Matt Lid.stl

I find printing awful since 5.2.0 Beta. Why is that ?

I am not sure that the latest Cura 5.1.0-Beat+304 is very good. I have to set the correct setting all the time for Retraction Travels. I have 4 times printed and it is still the same issues i.e. print the bottom of the box and it started well until at 3/4 of the print for the 1st layer, it becomes awful and clicking sound from the drive extruder. What is the cause please. What recommended settings please. My printer is Creality CR-10 Smart. I had no issues until now after I updated Cura revisions. I think there are some missing GCodes or faulty ones doing it. Also, at the last print of the box, 2 out of 3 surfaces it has been ironed well but 1 missing. Please reply by email. DanBox. 6.19H.gcode