So i was watching the print been finished
the buildplate lowers and than starts to raise again, forcing the finished print part 26 cm high into the moving printcores. Emergency buildplate lowering happend
buildplate stays low now
print core 1 does its cleanings then it went to the right side
ramping again into the finished print, it got jammed with force it went a bit back and it tried again to move the print core to the right
this time displacing the complete buildplate out of the metals holding clips with force
lifting the howl print with buildplate into the glass door that flew open….
after that i was standing next to printer to unplug the power cable before it went for a nother strike
i didn’t expect this from a ultimaker s5 pro bundle
its running the latest firmware and cura 5.0
but i have found similar issues in the forums about the same issue …
I don’t trust this machine at this moment