stencilarchitect

thanks for the insight and sorry for the late reply, Ive been experimenting with the surface mode and Ive been developing a new workaround at these kind of geometries where you need to have better control on the seams. Here is an example I did for a tubular geometry. and this is the surface geometry I've been developing with the help of Rhino and Grasshopper in addition to this (in my case) I realized that I needed to lower the print speed about 20 m/s and the layer height about 0.2mm , since the built up pression in higher amounts produces an over extrusion of material at the end of each layer since the transition between layers is not fast enough in my case and with my printer,( I don't know about other printers.) I hope this information can help some of you who wants more control in the path of your prints.

So there is a weird and unnecessary travel in Cura 5.1 (also 5) I tried all I've seen in the forums, optimize wall printing order, tried all seam hiding, etc. Any ideas? CFFFP_sello4.3mf