polydeus

Great, I'm going to try those StartUp and End Gcodes, and the print settings as well. Thank you very much for your time, GregValiant

Thanks for the reply, GregValiant. Here is the 3mf file of the calibration cube, sliced with Cura, with the settings I have been using. I prefer to use Cura for slicing, for some reason with the Creality slicer I don't have the same results. That's why I'm looking to set up a profile of my Cr 200B on the Cura slicer. CFFFP_xyzCalibration_cube.3mf

Hello everyone! I was looking for better gcodes for the CR 200B to use in cura and I was lucky to find this topic of yours. Reading Morgan's modified gcodes I found that he uses the G29 instruction for autoleveling, but the CR 200B printer doesn't actually have an autoleveling system. Maybe the G29 instruction fulfills another task that I don't know about and that must be there for something. I don't have much experience in this, maybe you guys have the answer I'm looking for. Thank you all