Jump to content

Hillbilly

Member
  • Posts

    4
  • Joined

  • Last visited

Personal Information

  • 3D printer
    Other 3D printer

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

Hillbilly's Achievements

0

Reputation

  1. Thanks for the Info dsp. I`ll try it out and let you know if it solves my Problem.
  2. Hello everyone . My name is Fred and I´m Relatively new in this community. I started last year , but have hardly communicated. with anyone sense then. Please except my deepest apologies for not writing sooner. I hope that I am not being too forward by asking for a little help. I know that this is a community that has a lot to do with Ultimaker 3D Printers and Cura,but I was also informed that I might be able to recieve some help although I donot own an Ultimaker Printer. I have a Labist ET4 3D Printer and I was wondering if anyone could help me with a couple of problems I have benn having. My first Problem is when I try to Print something with TPU Filament it will either print just the base or half way through the Print it will suddenly stop and discontinue the printing so that the Print will have not even started or will be half finished. I am sorry to say that I donot have any Pictures or Screenshots of these Problems,but Iam still hoping that someone might have an Idea of what might be the Problem and if it´s repairable. Any input would be most welcome. Thank you very much. FRED
  3. Thank you FaithV for the warm Welcome. I haven`t been following the forum very much since I joined because I haven`t had much time lately,but I do plan to learn as much as I can about 3D printing from the many Experts on this super forum. Thanks again for the warm Welcome.
  4. Hillbilly

    Intro

    Hello to everyone in the Ultimaker community. My name is Fred .I am known to this community under the Psodonym "Hillbilly". I am honored to be excepted as member of the Ultimaker community. I hope that I will be able to give help and/or advice as much as recieving help and /or advice. I know that there are lot of people in this Forum that much smarter and have more expieriance with 3D printers than I do. And I hope that in time I will become as savvy with 3D printers as you are. Thank You.
×
×
  • Create New...