Hello,
I'm having some difficulty connecting to my S5 via Cura (or browser). I am able to ping it, so it is connected to the same wifi network that I am. Turning it off and on again doesn't have much impact, although sometimes cura briefly connects to the printer, but not long enough to start a print job, for example. In addition, the S5 screen hangs on the 'Ultimaker' screen (rebooting it doesn't change that), so I'm unable to use that interface to troubleshoot. If I go to 'Manage printers' in Cura, my S5 is listed as one of the 'Connected printers' (not sure if that means anything). When I hit "Connect via Network', my S5 shows up as one of the options - however, when I click on it, the 'Connect' button is greyed out and there's a message saying 'This printer is not set up to host a group of printers'. FYI - S5 firmware is version 6.2.2 and Cura is version 5.0.0. Any advice on how to tackle this issue? At this point, I'd be happy if I could do a factory reset, as long as it stopped hanging on the 'Ultimaker' screen.